PitClamp Mini Reinforced Standard

Printing

PitClamp Mini Standard Settings:

6 Walls
Infill type: Cross Hatch (or gyroid) 10%
Supports: Normal (Snug) Supports with 3 degree threshold angle. Allow supports on part.
Seam: Nearest (or your personal preference)

• Recommended filament: PLA+

• All parts are intended to print in the provided file default orientation.

  • Printing the Base components in other orientations will cause structural weakness

If your printer is well calibrated and your material layer strength is optimal, the print-in-place Upper+Handle is recommended, found in the /Non-Standard folder.

Bill Of Materials

Per-side BOM:

PitClamp Mini v1.1 Hinge Pin

1x M5x20 Socket Cap Screw
1x M5 Nut

PitClamp Mini Lever Dogbones + Handle

1x M4x10 or M4x12 Socket Cap Screw
2x M4x25 Socket Cap Screw
3x M4 Nut

PitClamp Mini Lower v1.1 Reinforced

1x 77x16mm "Flat Mending Plate" AKA "Straight Braces"
2x M5x16 Socket Cap Screw
2x M5 T-Nut

77x16mm plate notes: These parts don't quite seem to be universally standard. Holes must be 5mm to support the 5mm hardware. Outer hole spacing needs to fall between 59mm and 61mm.

Print+Part kits: https://www.etsy.com/listing/1899330105/pitclamp-mini-reinforced-standard-base